TPMS Diagnostic Information – Kia Sedona, 2006-2020

05.17.2020

kia sedona

Over the next couple of months, we will be reviewing the best-selling Cars, SUVs, Minivans, and Trucks of 2019. During the month of May, we will focus on the best-selling minivans in 2019 in the United States.

Top Selling minivans

After the TREAD Act was mandated in 2007, all vehicles manufactured in the United States beginning in 2008, must be installed with direct or indirect TPMS systems.

 

The Kia Optima uses a direct TPMS system, which means TPMS sensors are installed in the wheel. If one or more tires indicate low tire pressure, the TPMS sensors will transfer the information to the vehicle’s ECU. An indicator light (low-line TPMS system) or each tire pressure will show on the dash (high-line TPMS system).

 

When a tire is inflated, rotated or changed in one or more tires of a Kia Optima, a TPMS relearn must be performed to write the IDs to the vehicle.

Kia Sedona Infographic

Type of TPMS system: 

  • Direct TPMS, TPMS sensors are installed in the wheel, tire pressure is communicated via radio frequency (RF) technology from the sensor to the vehicle’s ECU 

Options for TPMS sensor replacement:

  • All OE and Aftermarket TPMS sensor options and service kits can be found in the VT56, VT46 brands, VT55 and VT36 TPMS tools. 

Type of TPMS frequency: 

  • 315 MHz, years 2006-2015 
  • 433 MHz, years 2015-2020
  • 2015 models use both 315 and 433 frequencies

 

 

Type of relearn procedure: 

  • OBD relearn procedure
  • Auto relearn procedure

Type of TPMS tool required for TPMS reset:

  • VT56 TPMS tool with OBDII module 
  • VT55 TPMS tool

OBD relearn procedure, years 2006-2020:

  • OBDII module is required
  • Confirm TPMS sensors are properly installed
  • Adjust tire pressures to placard value
  • Activate TPMS tool on the left front tire sidewall next to the valve stem
  • Repeat for the RF/RR/LR tires
  • Apply OBD connector to DLC
  • Turn ignition to ON
  • Press OK on TPMS tool to transfer data to ECU
  • Disconnect OBD connector from DLC 
  • Turn ignition to OFF then ON
  • Wait for 5 minutes 
  • Drive for up to 20 minutes at 12 MPH

Auto relearn procedure, years 2006-2020:

  • OBDII connector is not required 
  • Confirm TPMS sensors are properly installed 
  • Adjust tire pressures to placard value 
  • Activate sensors with TPMS tool 
  • Drive for up to 10 minutes

Troubleshooting tips

Tire pressure 

If your Kia Sedona is equipped with a high-line TPMS system, the actual tire pressure is displayed on the dashboard. However, according to the Kia Sedona’s owner’s manual, the numbers displayed on the high-line system may differ from the numbers retrieved if using a tire pressure gauge.

TPMS Malfunction Indicator 

The TPMS malfunction indicator may be illuminated if snow chains are used or some separate electronic devices such as notebook computer, mobile charger, remote starter or navigation, etc., are used in the vehicle. This can interfere with the normal operation of the Tire Pressure Monitoring System.